cmotion cvolutionLCS - Setting Lens Limits in Combination with Knob Limits; Setting Slider Limits

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
56/112
4.8.4. Setting Lens Limits in
Combination with Knob Limits
Lens and Knob limits can be used in combination. This allows a dened range of the lens
scale to be controlled by a dened rotation of the knob. This feature is particularly useful when
requiring quick and precise focus racks for macro or close up work.
Note: Limits will remain programmed until they have been erased
intentionally by user, the motor is calibrated, or a factory reset is
performed.
■Set a motor limit as described above.
■Set a knob limit as described above.
Note: As long as a Knob Limit is set the letter K will be visible on the
display.
■To erase Limits, press both the LENS Button and the KNOB Button.
4.8.5. Setting slider Limits
The slider lens limit allows you to control a dened range on the lens using the full slider range.
Note: Limits will remain programmed until they have been erased
intentionally by user, the motor is calibrated, or a factory reset is
performed.
■Using the slider, move the motor to one of the two desired limit values.
■Push and hold the slider LENS Button, move the motor to the other desired value.
■Release the LENS Button.
Note: The slider LENS LED on the cvolution main unit will blink green
Note: As long as there is a limit currently set the LENS LED will
illuminate green. The limits will be shown on the hand unit display.
■To erase the limits press the slider LENS Button.