cmotion cvolutionLCS - Setting Limits; Setting Knob Limits; Setting Mechanical Knob Limits; Setting Lens Limits

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
55/112
4.8. Setting Limits
4.8.1. Setting Knob Limits
Knob Limits can be set to control the entire lens scale using a user dened portion of the knob
rotation. This can be used, e.g. for extremely fast focus racks.
■Turn the knob to the position you want to start the control range with
■Press and hold the KNOB Button on the front of the hand unit and move the knob
to to the end of the range.
■Release the KNOB Button to conrm the limits.
Note: Limits will remain programmed until they have been erased
intentionally by user, the motor is calibrated, or a factory reset is
performed.
■Press the KNOB button to remove the lens limit.
4.8.2. Setting Mechanical Knob Limits
Mechanical limits allow you to dene the rotation of the lens controlled by the same proportion
of the focus knob.
■Turn the lens to your rst desired position.
■Move the rst mechanical stop and secure against the knob’s position indicator.
■Turn the lens to the end position.
■Move the second mechanical stop and secure against the knob’s position
indicator.
Note: Mechanical Limits are only available on the advanced knob.
4.8.3. Setting Lens Limits
Lens Limits can be set for the knob, slider and zoom unit. They allow you to dene how much
of the lens scales will be controlled by the entire range of the controller..
■Using the focus knob, turn the lens to one of the two desired limits.
■Press and hold the LENS Button on the front of the hand unit and move the lens to
the other desired value.
■Release the LENS Button to conrm the limits.
Note: The displayed scale will ash while the lens limits are being set.
Note: Each limited scale will be displayed on the hand unit.
■Press the LENS button to remove the lens limit