cmotion cvolutionLCS - Cvolution System Setup for Mirror Rigs; Camin Setup; Stereographer Hand Unit Setup

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
90/112
6.3. cvolution System Setup for Mirror Rigs
The following instructions show you how to set up your cvolution system for use with your
choice of mirror rig. After successful setup, your hand unit display will directly read out correct
Interaxial and Convergence/Screen Plane distance values.
Note: Starting from software version 3.9.15 on the hand unit and
3.9.19 on the camin it is possible to control the following 3D rig axes:
Interaxial, Convergence, Mirror, Tilt and Rotation. The availability of
these axes depends on the manufacturer and type of your 3D rig.
6.3.1. camin Setup
■Connect the motors driving the rig to your camin.
■Make sure no cables are under strain.
■Connect the motor for Interaxial and Convergence to the desired motor ports. M7
for Conv and M8 for Interaxial are standard on a camin 8M/8M-TC.
Note: On advanced 3D rigs you can control more 3D axes, such as
Mirror or Tilt. These do not have dedicated motor ports on the camin.
Connect these to any available motor ports and assign accordingly via
the hand unit Motor menu.
6.3.2. stereographer hand unit Setup
To assign Convergence to the hand units knob and Interaxial to the slider follow these steps:
■Enter the MAIN MENU by pressing „Select“ twice.
■Scroll down to „KNOB“ and press „Select“. Set the knob to Convergence and the
direction as needed.
■Scroll to “Slider” and press „Select“. Set the Slider Scale to Interaxial and the
direction to right.
■Return to the MAIN MENU and enter “DIRECTION” and make sure M7 and M8
direction is set to right, or depending on the motor mount, left.
■Return to the MAIN MENU by selecting „Exit“. Calibrate Interaxial and
Convergence motors by pressing the „CAL“ button, rotating the SELECT button to
highlight “RIG” and pressing ‘SELECT”.
NOTE: To move from minimum to maximum by a clockwise knob
rotation set Knob direction to left. To move in a counter-clockwise
rotation set the direction to right.