cmotion cvolutionLCS - Mounting and Removing Knobs; Marker Rings; Mounting and Remvoing Sliders; Marker Strips

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
39/112
3.3.3. Mounting and Removing knobs
The basic or advanced knob can be mounted to and removed from the hand unit following a
few easy steps.
■Unscrew the two 4 mm hex screws at the back of the knob.
■Carefully lift the upper part of the knob, making sure you do not damage any
cables.
■Unscrew the two internal hex screws and remove the rear disc of the knob.
■To attach a basic or advanced knob to a hand unit, follow the previous steps in
reverse order.
Note: You may notice the threaded holes in the lower part of the knob
once it has been removed. These holes allow you to mount the knob in
dierent orientations if needed.
3.3.4. Marker Rings
The marker ring for the knob can be used to mark scale values and can be exchanged easily.
A locating pin ensures the ring does not rotate out of position once attached.
3.3.5. Mounting and Remvoing sliders
You can attach up to three sliders to the hand unit. Follow the steps above to remove the knob
if required
■Carefully align the connector on the back of the slider with the socket on the hand
unit or lower slider and press the slider into place.
■Secure the slider with the two hex screws using a 4mm Allen wrench.
Note: The sliders can be mounted for left or right hand operation.
Note: If the hand unit is only equipped with a knob, you will need to
remove the spacer block known as the bridge adapter before mounting
a slider.
3.3.6. Marker Strips
The marker strip can be used to mark scale values on the slider. It is kept in place by a magnet
and can be exchanged easily.