All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
24/112
1.11. cforce
cforce is a motor with built-in smart electronics that runs as fast as any top end motor but
produces less than 20 dB when high speed mode is disabled. It was developed in collaboration
with ARRI and oers 3 dierent mounting options: rod-to-rod, Hill bracket locking disc and
the “standard” rod bracket mounting with 2 dierent clamp versions, sporting unparalleled
mounting exibility. cforce motors are connected in a daisy chain fashion. I.e. a cable from the
rst motor is connected to the second, another cable runs to the third motor and the last is
cabled to the camin, thus achieving a less cluttered and expedited setup.
cforce motors can also be used with the compact LCS, knob solo, ENG-adapters and broadcast
camin
Standard clamp for 19mm
rods. 15mm rod adapter is
included in the sets
LBUS Le4p
connectors.
Set includes 0.4,
0.5, 0.6, 0.8mm
gears and one
gear carrier.
Status LED
Status LED
Red Voltage below 10 Volts, motor won’t function
Flashing Red
No LBUS data, i.e. no camin or no other LBUS
device present
Flashing Red/Green No controller assigned to motor
Flashing Yellow/Green Motor Calibration Request
Flashing Yellow Motor Calibration underway
Flashing Green Motor in manual mode, i.e. for manual calibration
Green Everything normal
To Next Page
Loading...