All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
42/112
3.4.4. Attach cvolution zoom
and handle to the Pan Bar
Using the cfast-czoom the zoom can be attached to the pan bar for comfortable control by the
operator. The cfast-czoom is composed of an arm, two locking discs and a cfastener. It can be
attached to any rod or bar 15-28 mm in diameter. The angle of the cvolution zoom to the pan-
bar can also be adjusted with the cfast-czoom, providing optimal comfort to the user.
Note: The arm of the cfast-czoom has two locking discs. One locking
disc is attached to the cfastener and the other is attached to the
cvolution zoom. The locking disc that holds the cfastener can be
attached to both ends of the arm to mount the zoom to both sides of
the pan bar.
■Attach the cvolution zoom to the cfast-czoom using the locking discs. Fasten
securely.
■Attach the cfastener to the pan bar (or any other rod 15-28 mm). Fasten securely.
Note: You can adjust the angle of the cvolution zoom to the pan-bar to
ensure maximum comfort.
■Loosen the tightening lever slightly.
■Rotate the cvolution zoom to your desired angle.
■Once you have established your desired position, tighten the lever again.
3.4.5. Using the cvolution pan-bar zoom
The pan-bar zoom clamp allows you to place the zoom unit onto to the pan bar and a rod of a
steadycam or gimbal application accordingly.
Using the LBUS connector you can connect the pan-bar zoom to the camin or directly to a
cforce motor.
■Attach the clamp to any rod or pan bar of 15-28 mm in diameter and fasten
securely
■Connect the pan-bar zoom to your compatible device via LCB cable
Note: The pan-bar zoom features 2 user bottons only. It is compatible
with the following cmotion and 3rd party devices: cforce motors,
cvolution camin 3M, ARRI Alexa Plus, Alexa Mini, UMC-4, AMC-1,
SMC-1 and EMC-1.
To Next Page
Loading...