cmotion cvolutionLCS - Motor Calibration

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
80/112
5.1.3. Motor Calibration
Each time the camera is powered ON; the scales displayed on the hand unit will ash yellow
and both the camera and hand unit will ask if you want to recalibrate the motors. It will not be
possible to control the motors until you have conrmed one of two options through either the
camera or the hand unit:
On the camera:
■Select “Skip” to use the previous calibration range.
■Select “ALL” to recalibrate the motors.
On the hand unit:
■Press the yellow ‘CAL’ button to access the calibration menu.
■Turning the “SELECT” wheel to select ‘Skip’ or ‘All’ as above.
■Press the “SELECT” button to conrm.