cmotion cvolutionLCS - Motor Calibration

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
83/112
5.2.2. Motor Calibration
Each time the camera is powered ON; the scales displayed on the hand unit will ash yellow
and both the camera and hand unit will ask if you want to recalibrate the motors. Both units
can select “Calibrate All” or “Skip”. It will not be possible to control the motors until you have
conrmed one of two options through either the camera or the hand unit:
Camera:
■Select “Skip” to use the previous calibration range.
■Select “ALL” to recalibrate the motors.
Hand unit:
■Press the yellow ‘CAL’ button to access the calibration menu.
■Turning the “SELECT” wheel to select ‘Skip’ or ‘All’ as above.
■Press the “SELECT” button to conrm.
NOTE: It is possible to set the torque for each individual motor through
either the Alexa Mini viewnder menu or the cvolution hand unit menu.
NOTE: It is possible to change the direction of each motor through
either the Alexa Mini viewnder menu or the cvolution hand unit menu.