cmotion cvolutionLCS - Connectors and Buttons on the Cvolution Hand Unit

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
14/112
1.5.1. Connectors and Buttons
on the cvolution hand unit
Buttons
ON button
Turn hand unit on or o
CAL button
Calibrate motors. Refer to section 4.4 on page 49
LENS button (KNOB)
Set lens limits
When pressed while holding CAL only the motor
associated with knob is calibrated
In the menu, LENS is context sensitive and serves
several purposes, as indicated on the display.
KNOB button
Set knob limits.
In the menu, KNOB is context sensitive and serves
several purposes, as indicated on the display.
RUN (GREEN button)
User congurable:
REC (start/stop the camera)
RET Trigger (Return function when using an ARRI
Alexa camera and a RVI cable)
UB 1, UB 2, UB 3 (triggers assignable camera user
button functions)
MARK (used in conjunction with cnder, cdisplay)
QSYN (used for quick sync)
RECM (start/stop recording meta data, with camin 8M-
TC only)
LASER (activates the laser pointer of cnder III)
O
RUN (RED button)
User congurable:
REC (start/stop the camera)
RET Trigger (Return function when using an ARRI
Alexa camera and a RVI cable)
UB 1, UB 2, UB 3 (triggers assignable camera user
button functions)
MARK (used in conjunction with cnder, cdisplay)
QSYN (used for quick sync)
RECM (start/stop recording meta data, with camin 8M-
TC only)
LASER (activates the laser pointer of cnder III)
O
MENU SELECT WHEEL
Enter menu by pressing twice
Scroll in menu
In SYNC menu: move slave motor
Connectors
CBUS port
The cvolution hand unit has a CBUS port on the top
side. This allows mounting the zoom module as well as
connection to the camin via cbus cable. It can also be
used for software updates.
Antenna connector
Connector for RF antenna. External antenna hand unit
only.