All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
110/112
9. Troubleshooting
General problems Problem Solution
Zoom does not work properly
Repower cvolution hand unit.
Make sure not to touch the zoom
controller while calibrating.
Calibration does not work Make sure camera is not running.
Camera RUN does not work
Make sure camin is not calibrating.
Any strange behavior Reset „Factory Settings“
RF problems Bad reception Check antenna.
Adjust RF Power.
No reception Check is selected RF channel is
correct for your RF version.
Make sure RF modules of camin
and cvolution hand unit match.
Motor problems Motor LED red
Motor does not move
camin 4M/8M only: use RS-2 to
power camin.
Motor has problems moving the
lens/rig
Increase torque, decrease ramp
speed.
camin 3M: Check Boost setting in
the main Menu.
camin 4M/8M only: Check if camin
power switch is set to ON 2.
Motors can't be synchronized Motors must be paired to be syn-
chronized.
Motor moves too slow Increase supply voltage.
camin 3M: Check Boost setting in
the main Menu.
camin 4M/8M only: Check if camin
power switch is set to ON 2.
Zoom axis does not move
Check zoom unit speed setting.
To Next Page
Loading...