cmotion cvolutionLCS - LED Status Cvolution Hand Unit

All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
16/112
1.5.2. LED Status cvolution hand unit
LED Status hand unit Status Solution
READY LED
OFF
hand unit o
Turn on system
GREEN
hand unit on
RED Blinking Battery low Change battery
RED
at startup: hand unit not ready
while online: power to camin
lost unexpectedly
RUN LED
OFF No run signal from camera
Camera in standby
Check cable
Check if RUN SIMUL is ON
GREEN Camera running OK
RED Camera error
Camera changing speed
Slider LED
OFF System idle
GREEN Lens limits have been set Remove lens limits by
pressing the „LENS“ button
RED
Slider does not have control
of assigned motor
Connect motor to appropri-
ate port on camin
Change slider conguration
to dierent motor
Blinking RED/GREEN Calibrating Wait for calibration to nish
Blinking GREEN Calibration armed Release “CAL” button to
calibrate
KNOB LEDs
(advanced knob
only and only
when used with
cdisplay II and
cfocas)
OFF System idle
MIDDLE LED GREEN Manual focus matches cfocas
range nder value
RED LED BAR Shows necessary focus cor-
rection