All content © 2017, cmotion GmbH. All specications subject to change without notice. http://www.cmotion.eu
62/112
4.13.2. Zooming
The zoom controller (joystick) is sensitive to pressure (sensitivity can be adjusted in the joystick
menu individually). To move the zoom motor, apply pressure to the zoom controller in the
direction you want to move the motor. The more pressure you apply, the faster the motor will
move. The zoom motor position will be shown in a bar graph in the zoom menu.
4.13.3. Zoom Speed
If you want to adjust zoom speed more often, assign BUTTON UP to SPD UP and BUTTON
DOWN to SPD DOWN. Now you just need to press the BUTTON UP or DOWN to change zoom
speed.
The zoom speed value is shown in the display of the zoom controller as a percentage value and
a bar graph.
If BUTTON UP or BOTTON DOWN is asigned to another function than SPD UP and SPD DOWN,
you can change the speed in the joystick menu.
4.13.4. zoom Buttons
On the back of the zoom module are two blue user buttons.
LENS / USER BUTTON 1 (for latest revision units from 2015) and ZAP / USER BUTTON 2 (for
latest revision units from 2015).
Buttons can be congured freely to ZAP, LENS, REC, RET, MARKER, SPD UP or SPD DOWN.
ZAP
The ZAP function allows you to override the zoom speed setting and to drive the motor at
maximum speed while maximum pressure is applied to the zoom controller.
LENS
The LENS function serves the same purpose as the LENS buttons on the slider and the hand
unit. I.e. single motor calibration / setting a lens limit.
Note: When a button is assigned to LENS and pressed while holding CAL only the motor
associated with the corresponding axis is calibrated.
REC
The REC function triggers the camera and is used to start and stop the camera
RET
The RET function replays the last clip from the camera
MARKER
The MARKER function allows you to set markers on the zoom scale and to jump between those
To Next Page
Loading...