Compaq PROLIANT ML370 User Manual

Server Features 1-5
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant ML370 Setup and Installation Guide Comments:
Part Number: 120137-002 File Name: b-ch1 Server Features Last Saved On: 12/13/99 3:42 PM
For information on installing a SCSI hard drive in your ProLiant ML370
server, refer to the documentation on the Documentation CD and the
SmartStart Support Software CD shipped with your server. When you
configure SCSI drives from the support software provided by the operating
system vendor, you must also run the driver support diskettes that shipped with
your server to properly configure the SCSI drive controls. For additional
information, refer to the Integrated SCSI Controller Setup Guide on the
Documentation CD.
Network Controller
The standard Network Integrated Controller (NIC) provided with your
ProLiant ML370 server is a NC3163 Fast Ethernet NIC Embedded 10/100
WOL installed
on a PCI local bus. The controller provides an RJ-45 connector
for a 10BaseT or 100TX Ethernet network connection.
For information concerning the integrated network controller, refer to the
Documentation CD shipped with your server.
Removable Storage Media
Your Compaq ProLiant ML370 server provides a maximum of 10 drive bays.
Four bays are located in the removable media drive area and six are located in
the hot-plug drive cage. Standard configurations for drive bays include:
 One-third height dedicated, removable media drive bay occupied by a
1.44-MB diskette drive
 One-half height removable media drive bay occupied by an
IDE CD-ROM drive
 Two available half-height, 5.25-inch, removable media drive bays
 Support for up to six 1-inch hot-plug Wide Ultra2 SCSI drives in the
hot-plug drive cage

Compaq PROLIANT ML370 Specifications

General

Brand	Compaq
Model	PROLIANT ML370
Category	Server
Language	English