Compaq PROLIANT ML370 User Manual

Installing the Rack Model ProLiant ML370 3-21
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant ML370 Setup and Installation Guide Comments:
Part Number: 120137-002 File Name: d-ch3 Installing the Rack Model Last Saved On: 12/13/99 3:43 PM
Figure 3-14. Attaching a cable management arm bracket to the server
Loading the Rack Server
When mounting multiple servers, only install one set of mounting brackets at a
time. Make sure that the brackets align perfectly, the server fits in the rack, and
the faceplate fits securely with thumbscrews. Then, proceed to install the next
set of mounting brackets.
WARNING: To reduce the risk of personal injury or damage to the equipment, a
minimum of two people must lift the server into the rack. The server weighs 50
pounds (22.6 kilograms). If the unit is to be loaded above chest level, a third
person must assist in aligning the rails while the other two people support the
unit.
IMPORTANT: To keep the server lighter and more manageable, do not install drives in
the server until after you load the server into the rack.

Compaq PROLIANT ML370 Specifications

General

Brand	Compaq
Model	PROLIANT ML370
Category	Server
Language	English