Compaq PROLIANT ML370 User Manual

4-8 Compaq ProLiant ML370 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant ML370 Setup and Installation Guide Comments:
Part Number: 120137-002 File Name: e-ch4 Installing Hardware Options Last Saved On: 12/10/99 12:22 PM
Tower Model
Remove the large access panel:
1. If the server is on, turn it off and disconnect the power cord.
2. Disconnect any other external equipment connected to the computer.
3. Open the front bezel.
4. Loosen the thumbscrews  located on the left side of the front chassis.
5. Slide the large access panel toward the rear of the unit ½ inch (1.5 cm).
6. Lift out and remove the panel  .
2
1
Figure 4-6. Removing the large access panel (tower server)
7. Turn the large access panel over to locate the system configuration label
system board. This label provides information on installing and
configuring drives, installing memory, installing additional processors,
and setting switches.
8. Set the panel to the side and use the label to locate components inside
the chassis.
Rack Model
Remove the large access panel:
1. If the computer is on, turn it off and disconnect the power cord.
2. Disconnect any other external equipment connected to the computer.

Compaq PROLIANT ML370 Specifications

General

Brand	Compaq
Model	PROLIANT ML370
Category	Server
Language	English