Compaq PROLIANT ML370 User Manual

Installing the Rack Model ProLiant ML370 3-33
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant ML370 Setup and Installation Guide Comments:
Part Number: 120137-002 File Name: d-ch3 Installing the Rack Model Last Saved On: 12/13/99 3:43 PM
2. Insert the SmartStart and Support Software CD  into the CD-ROM
tray, extend the four clips on the CD-ROM tray
 to hold the CD in
place, and push lightly on the edge of the tray
 to close.
2
3
1
2
Figure 3-26. Inserting the CD into the CD-ROM drive (rack server)
NOTE: The load mechanism or tray on the CD-ROM drive installed in your server may
look different from the one shown in the figure above.
3. After running Power-On Self-Test (POST), the system automatically
starts from the CD and begins the SmartStart installation. Refer to the
SmartStart documentation included with your Server Setup and
Management pack to configure the system and load the operating
system.
Refer to the Compaq Management for additional information on server
management and SmartStart utilities.
Using Diagnostic Tools
ProLiant ML370 software and firmware diagnostic tools include:
 Power-On Self-Test (POST)
 Diagnostics (DIAGS)
 ROMPaq utilities to upgrade flash ROMs
 Automatic Server Recovery-2 (ASR-2)

Compaq PROLIANT ML370 Specifications

General

Brand	Compaq
Model	PROLIANT ML370
Category	Server
Language	English