Engineering Manual Engineer Menu 2-8
121
OCCUPANCY SET System set with people on site
ON LINE TO # Online to remote PC
ON-SITE RESTART On-site restart
PA WARDS:- PA alarm on wards
PANEL LID TAMPER Control panel lid tamper
PANEL STARTED System powered up
PANEL TAMP OMIT Panel lid timer omitted after confirmation timer expired
PANIC ALARM #### PA Alarm from zone number ####
PANIC CODE ## PA code from user number ##
PANIC CODE ### PA code from user number ###
PANIC CODE #### PA code from user number ####
PANIC REST. #### Panic Alarm on zone #### restored
PAYMENT EXPIRED System payment timer has expired
PSTN FAULT Telephone line fault detected
PSTN RESTORE Telephone line fault restored
PSU BATT A #### PSU Battery zone #### active
PSU BATT H #### PSU Battery zone #### healthy
PSU FUSE A #### PSU Fuse zone #### active
PSU FUSE H #### PSU Fuse zone #### healthy
PSU PWR A #### PSU Power zone #### active
PSU PWR H #### PSU Power zone #### healthy
REARM ,OMIT #### Zone #### omitted after confirmation timer has expired
REARM SYSTEM System rearmed
REARM TAMP OMIT
REARM WARDS:- Wards re-armed
REINST WARDS:- Wards reinstated
REM RESET ACTIVE Remote reset via the REM RESET input terminal (RedCARE)
REM RESET FAILED Remote reset failed
REM RESET PASSED Remote reset successfully carried out
REM SERVICE CALL Remote service call in progress
REM TAMPER Not used
RESET WARDS:- User or engineer has reset wards
SEC KEY NO #### Security key operated on zone number ####
SERVICE CALL END Not used
SERVICE REQUIRED System requires a service visit (Service Timer expired)
SET EXT L.FAULT System set with external line fault
SET FAIL #### Set fail caused by zone ####
SET FAIL WARDS:- Set fail for wards
SET GENERAL FLT System set with a general fault present
SET NO ACTIVITY Not used
SET PSTN FAULT System set with a line fault present
SET PSU BATT FLT System set with a PSU Battery fault present
SET PSU FUSE FLT System set with a PSU Fuse fault present
SET PSU PWR FLT System set with a PSU Power fault present
SET WARDS:- Wards set
SET WITH AC FAIL Wards set with a mains fault present
SET WITH MSK FLT System set with zones masked
SH.KEY OFF #### Shunt key zone #### deactivated
SH.KEY ON #### Shunt key zone #### activated
SHNT #### REINST Shunted zone #### reinstated
SHUNT CODE ## User ## of type "Shunt" entered passcode to isolate zones
SHUNT CODE ### User ### of type "Shunt" entered passcode to isolate zones
SHUNT CODE #### User #### of type "Shunt" entered passcode to isolate zones
SHUNT END #### Not used
SHUNT GROUP ## Shunt Group ## used to isolate zones
SHUNT START #### Not used
SHUNT ZONE #### Zone #### shunted
SILENT PA #### Silent Panic Alarm zone #### activated
To Next Page
