D-Link xStack DGS-3120 Series Reference Guide

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
360
Complete the JWAC authentication information in this window to set the JWAC page settings. Click the Apply
button to implement the changes made. Click the Set to default button to go back to the default settings of all
elements.
Compound Authentication
Compound Authentication settings allows for multiple authentication to be supported on the Switch.
Compound Authentication Settings
Users can configure Authorization Network State Settings and compound authentication methods for a port or ports
on the Switch.
To view this window, click Security > Compound Authentication > Compound Authentication Settings as
shown below:
Figure 8-52 Compound Authentication Settings window (RI Mode Only)

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)