xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
253
Enter the route source used here.
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
Click the Edit button under Set Clause to see the following window.
Figure 5-148 Route Map Settings - Set Clause window
The fields that can be configured are described below:
Parameter Description
Use the drop-down menu to Add or Delete a sequence entry.
Next Hop
Click the radio button to set the next hop attribute.
IP Address - IP address to set.
Metric
(0-4294967294)
Click the radio button to enter the metric.
The router will not send metrics associated with a route by default unless the metric is
egress set in the route map.
If the route receives a route with a metric, then this metric will be used in best path
selection. This can be overwritten by the metric that is ingress set for the route. If the
received route has neither metric attribute nor metric ingress metric set, then the default
metric (0) will be associated with the route for the best path selection. If med-missing-as-
worst is enabled for the router, then a value of infinite will be associated with the route.
This will take effect for both ingress and egress directions.
Select the metric type used here. Options to choose from are Type-1 and Type-2.
Click the Apply button to accept the changes made.
Click the <<Back button to return to the previous window.
MD5 Settings (RI Mode Only)
The MD5 Configuration allows the entry of a 16 character Message Digest version 5 (MD5) key which can be used
to authenticate every packet exchanged between OSPF routers. It is used as a security mechanism to limit the
exchange of network topology information to the OSPF routing domain. This page is used to configure an MD5 key
and password.
To view the following window, click L3 Features > MD5 Settings, as shown below:
To Next Page
Loading...
Need help?
General
