xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
73
Parameter Description
Use the drop-down menu to back up configuration or log.
Specify the schedule to back up the configuration or log.
Specify the backup file name.
Use the drop-down menu to enable or disable the backup schedule.
Click Add to create a new entry.
Click Delete All to remove all the entries from the table.
Click Edit to modify the specific entry.
Click Delete to remove the specific entry.
SD Card Execute Settings
This window is used to configure a schedule to execute the configuration on file system.
To view the following window, click Management > SD Card Management > SD Card Execute Settings, as
shown below:
Figure 3-56 SD Card Execute Settings window
The fields that can be configured are described below:
Parameter Description
The filename of the configuration on file system.
Increment
If this option is specified, the current configuration will not be reset before executing the
Reset
If this option is specified, the current configuration will be reset before executing the
The time range for schedule to execute the configuration.
Enable or disable the executive schedules.
Click Execute to execute configuration on file system.
Click Add to create a new entry.
Click Delete All to remove all the entries from the table.
Click Edit to modify the specific entry.
Click Delete to remove the specific entry.
To Next Page
Loading...
Need help?
General
