D-Link xStack DGS-3120 Series - Dhcpv6 Relay

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
411
Figure 9-17 DHCP Conflict IP Window
Click the Clear All button to remove all the entries listed in the table.
DHCPv6 Relay
DHCPv6 Relay Global Settings
This window is used to configure the DHCPv6 relay function.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Global Settings as
shown below:
Figure 9-18 DHCPv6 Relay Global Settings window
The fields that can be configured are described below:
Parameter Description
DHCPv6 Relay State
Click the radio buttons to enable or disable the DHCPv6 relay function.
DHCPv6 Relay Hops
Count (1-32)
Enter the number of relay agents that have to be relayed in this message. The
default value is 4.
Click the Apply button to accept the changes made for each individual section.
DHCPv6 Relay Settings
This window is used to configure the DHCPv6 relay state of one or all of the specified interfaces, and add or
display a destination IPv6 address to or from the switch’s DHCPv6 relay table.
To view this window, click Network Application > DHCP > DHCPv6 Relay > DHCPv6 Relay Settings as shown
below:
Figure 9-19 DHCPv6 Relay Settings window
The fields that can be configured are described below: