D-Link xStack DGS-3120 Series - CFM Port Settings; CFM MIPCCM Table

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
431
choose from are values between 0-7.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
CFM Port Settings
This window is used to enable or disable the CFM function on a per-port basis.
To view this window, click OAM > CFM > CFM Port Settings, as shown below:
Figure 10-10 CFM Port Settings Window
The fields that can be configured are described below:
Parameter Description
Unit
Select the unit ID to be configured. (EI Mode Only)
From Port / To Port
Use the drop-down menus to select a range of ports to be configuration.
State
Use the drop-down menu to enable or disable the state of specific port regarding the
CFM configuration.
Click the Apply button to accept the changes made.
CFM MIPCCM Table
This window is used to show the MIP CCM database entries.
To view this window, click OAM > CFM > CFM MIPCCM Table, as shown below:
Figure 10-11 CFM MIPCCM Table Window