D-Link xStack DGS-3120 Series - Loopback Interface Settings (RI Mode Only)

xStack® DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch Web UI Reference Guide
47
Click the View All IPv6 Address link to see the following window.
Figure 3-13 IPv6 Interface Settings window
Click the <<Back button to return to the previous page.
Click the Delete button to remove the specific entry.
After clicking the View Neighbor Discover link, the following page will appear:
Figure 3-14 IPv6 Interface Settings - View Neighbor Discover window
Click the <<Back button to return to the previous page.
Loopback Interface Settings (RI Mode Only)
This window is used to configure loopback interfaces. A loopback interface is a logical IP interface which is always
active, until a user disables or deletes it. It is independent of the state of any physical interfaces.
To view the following window, click Management > IP Interface > Loopback Interface Settings, as shown below:
Figure 3-15 Loopback Interface Settings window
The fields that can be configured are described below:
Parameter Description
Interface Name
Enter an interface name.
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the existing entries.
Click the Add button to create a new entry.
Click the Delete All button to remove all the entries listed in the table.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Click the Add or Edit button to see the following window.