©
200508 4-7
Removal and installation
ZF S5-42 GEARBOX
ΛΦ45/55 series
3
4
Installing selector shaft oil seal
1. Fit the selector shaft bush (8) using the
special tool (DAF no. 0192545). Heat the
housing (2), if necessary, in order to facilitate
assembly.
2. Lubricate the circumference of the seal (9)
with a soap solution. Fit the seal with special
tool (DAF no. 0535659) in the housing, with
the sealing lip on top.
3. Fit the wiper seal (10).
4. Place the special tool (DAF no. 0192546) on
the selector shaft (7). Fit the selector shaft.
5. Heat the selector finger (6) to a max. of
100″C. Install the selector shaft (7) in the old
position according to the markings made.
6. Fit the spring washer (5).
7. Install the retainer (3). To ease fitting, the
housing (2) around the bore can be heated to
120″C.
8. Fit the protective cap (11).
9. Install the shifting arm (12) in the old position
in accordance with the markings made.
Tighten the shifting arm locking bolt to the
specified torque. See "Technical data".
10. Tighten the bleeder (4) to the specified
torque. See "Technical data".
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
