ALLISON 1000 & 2000 AUTOMATIC GEARBOXES
4-6
©
200508
Removal and installation
7
ΛΦ45/55 series
3
4.4 REMOVING AND FITTING SELECTOR SHAFT OIL SEAL
Removing selector shaft oil seal
1. Put the gearbox selector lever in the neutral
position.
2. Remove the selector cable from the selector
switch.
3. Remove the attachment nut from the
selector shaft.
The selector shaft must not be
turned while the attachment nut is
being loosened or tightened. While
loosening or tightening the
attachment nut, lock the selector
shaft using the selector arm and an
appropriate tool.
4. Remove the selector switch.
5. Fit special tool (DAF no. 1453124) over the
selector shaft and turn it into the oil seal.
6. Tighten the nut on the special tool (2) and
remove the oil seal from the selector shaft
bush.
7. Check the selector shaft bush and the
selector shaft for irregularities and wear.
Note:
Slight irregularities can be smoothed using
fine sandpaper.
V3 00 482
}
2
V3 00 560
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
