PROP SHAFTS
3-2
©
200508
Removal and installation
10
ΛΦ45/55 series
3
3.2 REMOVAL AND INSTALLATION, PROP SHAFT/INTERMEDIATE SHAFT
ASSEMBLY
Removing prop shaft/intermediate shaft
assembly
1. When removing one of the shafts in vehicles
with multiple shafts (prop shaft and
intermediate shafts), the other shaft must be
tied to the chassis or intermediate beam in
such a way that it does not obstruct the
various activities.
Note:
Always transport and store shafts
horizontally to avoid damage and
subsequent imbalance.
Support the shaft in at least two places. If
possible, hang the shaft in a hoist, using two
sturdy ropes.
2. Remove the attachment bolts from the
flanges and carefully lower the shaft to the
ground.
Now remove the shaft from under the
vehicle.
Installing prop shaft/intermediate shaft
assembly
Note:
After repairs have been carried out or a shaft has
been replaced, the marks on the shafts must be
opposite each other.
1. Fit the shaft under the vehicle. Use a hoist if
possible.
2. Tighten the attachment bolts to the specified
torque. See "Technical data".
W 3 06 016
==
W 3 06 019
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
