ZF 6S-850 GEARBOX
4-10
©
200508
Removal and installation
5
ΛΦ45/55 series
3
RHD model
Removing selector shaft oil seal
1. Mark the gearbox lever relative to the
selector shaft and remove the control lever
with the gearbox control. If necessary,
disconnect the torque rod.
2. Remove the bearing housing attachment
bolts and slide it off the selector shaft.
3. Drive the dust and oil seals out of the bearing
housing. If necessary, the selector shaft
bearing bush can now also be replaced with
special tool (DAF no. 0694818). Press the
bearing bush on the spring side 2 mm under
the edge.
Installing selector shaft oil seal
1. Apply a small of amount of liquid gasket to
the oil seal and fit it in the bearing housing
using special tool (DAF no. 0535659). Now
fit the dust seal in the bearing housing using
special tool (DAF no. 0535659).
2. Apply grease to the oil seal lips. Fit a new
O-ring to the selector shaft housing. Fit the
selector shaft housing over the selector
shaft.
3. Fit the attachment bolts and the gearbox
control. Tighten the bolts to the specified
torque. See "Technical data". Check that all
gear changes function properly.
V3 00 400
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
