EasyManuals Logo

DAF LF45 Series Service Manual

DAF LF45 Series
254 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
©
200508 4-7
Automatic gearbox
DIAGNOSTICS
ΛΦ45/55 series
3
1
Main code Sub-code RECOMMENDED PROCEDURES
Engine and turbine rev test when engaging neutral
53 08
18
28
29
38
39
48
49
58
59
68
69
78
99
Check the following points:
1. engine speed sensor and output shaft speed sensor are connected. The
connectors are undamaged and clean.
2. no interruptions or short circuits between wires or earth in sensor wiring.
3. let the engine idle in neutral while the vehicle is on the brake.
Check the following points:
1. specified dip stick.
2. oil level.
If all these points are in order, contact your Allison dealer.
Transmission ratio test immediately after changing gear
54 01,07
10,12
17,21
23,32
34,43
45,54
56,65
70,71
80,81
83,85
86,92
93,95
96,97
Check the following points:
1. engine speed sensor and output shaft speed sensor are connected. The
connectors are undamaged and clean.
2. no interruptions or short circuits between wires or earth in sensor wiring.
3. let the engine idle in neutral while the vehicle is on the brake.
Check the following points:
1. specified dip stick.
2. oil level.
If all these points are in order, contact your Allison dealer.
Main code Sub-code RECOMMENDED PROCEDURES
Pressure in coupling 3 immediately after changing gear
55 17
87
97
Check the following points:
1. engine speed sensor and output shaft speed sensor are connected. The
connectors are undamaged and clean.
2. no interruptions or short circuits between wires or earth in sensor wiring.
3. let the engine idle in neutral while the vehicle is on the brake.
Check the following points:
1. specified dip stick.
2. oil level.
4. check that there is no interruption or short circuit between the wiring or
earth connection in the coupling 3 pressure switch wiring.
5. Check the following points:
1. main connector is properly connected, clean and undamaged.
2. ECU connector is properly connected, clean and undamaged.
3. rev sensor is properly connected, clean and undamaged.
If all these points are in order, contact your Allison dealer.
DAF LF Gearboxes and Clutch Service Manual

Table of Contents

Other manuals for DAF LF45 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DAF LF45 Series and is the answer not in the manual?

DAF LF45 Series Specifications

General IconGeneral
BrandDAF
ModelLF45 Series
CategoryTrucks
LanguageEnglish

Related product manuals