Danfoss VACON 100 FLOW Series - Page 231

11.12.10 (ID 724) Autoreset: Unit Overtemperature
Location in the menu: P3.10.10
Use this parameter to enable the automatic reset after a fault caused by unit overtemperature.
11.12.11 (ID 725) Autoreset: Motor Overtemperature
Location in the menu: P3.10.11
Use this parameter to enable the automatic reset after a fault caused by motor overtemperature.
11.12.12 (ID 726) Autoreset: External Fault
Location in the menu: P3.10.12
Use this parameter to enable the automatic reset after an external fault.
11.12.13 (ID 738) Autoreset: Underload Fault
Location in the menu: P3.10.13
Use this parameter to enable the automatic reset after an underload fault.
11.12.14 (ID 776) Autoreset: PID Supervision Fault
Location in the menu: P3.10.14
Use this parameter to enable the automatic reset after a PID supervision fault.
11.12.15 (ID 777) Autoreset: EXT PID Supervision Fault
Location in the menu: P3.10.15
Use this parameter to enable the automatic reset after an external PID supervision fault.
11.12.16 (ID 1569) Fault Simulation
Location in the menu: P3.10.16
With this parameter it is possible to simulate the different faults without them being actually active. For example simulating an over
current situation. In the drive interface point of view the behavior is identical to actual fault situations.
Selection
Name
Description
B00
1
10
Over current fault (F1)
B01
2
10
Over voltage fault (F2)
B02
4
10
Under voltage fault (F9)
B03
8
10
Output phase supervision fault (F11)
B04
16
10
Earth voltage fault (F3)
B05
32
10
System fault (F8)
B06
64
10
Over temperature warning (W14)
B07
128
10
Over temperature fault (F14)
(1)
B08
256
10
Reserved
B09
512
10
Reserved
B10
1024
10
Fan cooling fault (F32)
1
The warning bit needs to be high also for this fault simulation to work.
AB298035655957en-000201 / DPD01083 | 231Danfoss A/S © 2023.08
Parameter Descriptions
VACON® 100 FLOW
Application Guide