Global Prefix/Suffix
Product Reference Guide 131
6. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
7. The resulting message string would appear as follows:
Scanned barcode data:12345
Resulting message string output: $12345
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. To configure this feature, scan the ENTER/EXIT barcode to place the unit in
Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” barcode followed by
the digits (in hex) from the Alphanumeric characters in Appendix E, Keypad representing your
desired character(s). If less than the expecte
d string of 20 characters are selected, scan the
ENTER/EXIT barcode to terminate the string. Reference the section, "Example: Setting a
Prefix"on page 130, for more information. Exit programming mode by scanning the ENTER/
EXIT barcode once again.
ENTER/EXIT PROGRAMMING MODE
Set Global Prefix
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to abort and not save the
entry string. You can then start again at the beginning.
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D
To Next Page
Loading...
Need help?
General
