Getting Started
30 Gryphon™ I GD4100/GM4100
Configure Other Features
If your installation requires different programming than the standard factory default settings,
the following sections of this manual allow configuration of non-interface-specific settings you
might require:
General Features
.
General Features includes programming for scanning, beeper and LED
indicators and other such universal settings.
Symbologies
.
Includes options concerning the barcode label types (symbologies). These settings
allow you to enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by scanning the following label.
Transmit Software Version
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some
options and want to restore the Custom Default Configuration that may have been saved in the
scanner, scan the Restore Custom Default Configuration barcode below. This will restore the
custom configuration for the currently active interface.
NOTE
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
To Next Page
Loading...
Need help?
General
