Getting Started
28 Gryphon™ I GD4100/GM4100
Display
The Gryphon GM4100 is available with an optional Display. The Display features 4 lines and
16 characters, and offers icons and three additional keys to allow a better interaction with a
remote host.
Fonts, contrast, backlight and other parameters can be configured for
the Display. See "Display"
on page 60 and "Message Formatting" on page 379 for m
ore information.
Figure 15. Gryphon™ I Display
Programming
The reader is factory-configured with a set of default features standard. After scanning the
interface barcode from the Interfaces section, you can select other options and customize your
reader through use of the instructions and programming barcodes available in
the
corresponding features section for your interface, and also the Data Editing and Symbologies
chapters of this manual.
Using the Programming Barcodes
This manual contains feature descriptions and barcodes which allow you to reconfigure your
reader. Some programming barcode labels, like the "Restore Custom Default Configuration"on
page 30, require only the scan of that single label to enac
t the change. Most of the programming
labels in this manual, however, require the reader to be placed
in Programming Mode prior to
scanning them. Scan an ENTER/EXIT barcode once to enter Programming Mode. Once the
reader is in Programming Mode, you can scan a number of parameter settings before scanning
the ENTER/EXIT barcode a second time, which will then accept your changes, exit
Programming Mode and return the reader to normal operation.
NOTE
There are some exceptions to the typical programming sequence described
above. Please read the description and setting instructions carefully when
configuring each programmable feature.
To Next Page
Loading...
Need help?
General
