Product Reference Guide 67
Chapter 4
Interfaces
Interface Selection
Each reader model will support one of the following sets of host interfaces:
General Purpose Models
RS-232
RS-232 OPOS
USB
Keyboard Wedge
Wand Emulation
Retail Point of Sale Models
RS-232
RS-232 OPOS
USB
IBM 46XX
Configuring the Interface
Scan the programming barcode from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding
chapter in this manual (also listed in Table 6) to configure any desired settings and features
associated with that interface.
NOTE
Unlike some other programming features and options, interface selec-
tions require that you scan only one programming barcode label. DO
NOT scan an ENTER/EXIT barcode prior to scanning an interface selection
barcode.
Some interfaces require the scanner to start in the disabled state when
powered up. If additional scanner configuration is desired while in this
state, pull the trigger and hold it for five seconds. The scanner will
change to a state that allows programming with barcodes.
To Next Page
Loading...
Need help?
General
