RS-232/USB-Com Interfaces
82 Gryphon™ I GD4100/GM4100
Beep On ASCII BEL
When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on
the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other
important event.
ENTER/EXIT PROGRAMMING MODE
Beep On ASCII BEL = Disable
Beep On ASCII BEL = Enable
Beep On Not on File
This option enables/disables the action of the reader to sound a three beep sequence upon
receiving a Not-On-File (NOF) host command.
ENTER/EXIT PROGRAMMING MODE
Beep On Not On File = Disable
Beep On Not On File = Enable
DEFAULT
To Next Page
Loading...
