Programming
Product Reference Guide 29
Select the Interface Type
Upon completing the physical connection between the reader and its host, proceed directly to
"Interfaces"on page 67 for information and programming for the in
terface type the reader is
connected to (for example: RS-232, Keyboard Wedge,
USB, etc.) and scan the appropriate
barcode in that section to select your system’s correct interface type.
Configure Interface Settings
If after scanning the interface barcode from the Interfaces section, your installation requires you
to select options to further customize your reader, turn to the appropriate sec
tion for your
interface type as listed below:
• RS-232 ONLY Interface, starting on page 73
• Keyboard Interface, starting on page 99
• USB-OEM Interface, starting on page 113
• IBM 46XX Interface, starting on page 117
• Wand Emulation Interface, starting on page 123
To Next Page
Loading...
Need help?
General
