Product Reference Guide 13
Chapter 2
Getting Started
About the Reader
Advancements in the LED technology used in this reader significantly improve the illumination
of the target field of view, resulting in higher scan efficiency. Whether used in Single Trigger or
Continuous Mode, the ergonomic design of the reader will help to promote comfortable
handling during extended periods of use.
See "Interface Selection"on page 67 for a listing and descriptions of available interface sets by
model type.
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged. If
any damage occurred during shipment, contact Datalogic Technical Support. Information is
shown on page 9.
KEEP THE PACKAGING. Should the unit ever require se
rvice, it should be returned in its
original shipping container.
Setting Up the Reader
Depending on whether you are using a Corded or Mobile version of the Gryphon, follow the
steps provided in this section to connect and get your reader up and communicating with its
host.
1. Install the Batteries
2. Install the Interface Cable (Corded) or Connect the Base Station (Mobile)
3. Select the Interface Type
4. Configure Interface Settings (only if not using factory settings for that interface)
5. Configure Other Features (if modifications are needed from factory settings)
To Next Page
Loading...
Need help?
General
