Product Reference Guide 391
Appendix C
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for feature d
escriptions and programming barcodes for each
parameter. A column has also been provided for recording of your preferred
default settings for
these same configurable features.
Table 51. Standard Defaults
Parameter Default Your Setting
Page
Numb
er
General Features
Double Read Timeout
0.4 Second 33
Label Gone Timeout
160 ms 35
Sleep Mode Timeout
Disable 37
Power On Alert
4 Beeps 39
Good Read: When to Indicate
After Decode 40
Good Read Beep Type
Mono 41
Good Read Beep Frequency
Medium 42
Good Read Beep Length
80 ms 42
Good Read Beep Volume
High 44
Good Read LED Duration
LED on until
next trigger pull
45
Scan Mode
Trigger Single 47
Stand Mode Triggered Timeout
0.5 second 49
Stand Detection
Switch to Stand mode 51
Stand Mode Sensitivity
Medium 52
Scanning Active Time
5 Seconds 53
Flash On Time
1 Second 55
To Next Page
Loading...
Need help?
General
