Sleep Mode Timeout
Product Reference Guide 37
Sleep Mode Timeout
Specifies the timeout value for the reader to enter low power Sleep Mode. When Sleep Mode is
enabled the reader cannot receive commands from the Host or base station.
In order for the reader to enter Sleep Mode, the following cond
itions must be met:
Corded version .
RS-232 interface and trigger single, trigger multiple or trigger pulse.
Mobile version .
Sleep state is allowed only on the handheld (not on the base) when trigger
single, trigger multiple or trigger pulse are set, and when the reader is not charging the battery.
ENTER/EXIT PROGRAMMING MODE
Sleep Mode Timeout = Disable
Sleep Mode Timeout = 1 Second
Sleep Mode Timeout = 2 Seconds
Sleep Mode Timeout = 3 Seconds
Sleep Mode Timeout = 4 Seconds
DEFAULT
To Next Page
Loading...
