316
QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Programming Mode
The following indications ONLY occur when the reader is in Programming Mode:
INDICATION DESCRIPTION LED BEEPER
Label Program-
ming Mode
Entry
A valid programming label has
be
en scanned.
LED blinks continuously
Reader sounds four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of
Labe
l
A label has been rejected. N/A
Reader sounds three times at
low
est frequency & current
volume.
Label Program-
ming Mode
Acceptance of
Part
ial Label
In cases where multiple labels
m
ust be scanned to program
one feature, this indication
acknowledges each portion as
it is successfully scanned.
N/A
Reader sounds one short beep
at
highest frequency & current
volume.
Label Program-
ming Mode
Acceptance of
Program
ming
Configuration option(s) have
bee
n successfully pro-
grammed via labels and the
r
eader has exited Program-
ming Mode.
N/A
Reader sounds one high fre-
quency beep and four low fre-
quency beeps followed by
re
set beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Reader sounds two times at
l
ow frequency and current vol-
ume.
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not
passed its automatic Selftest and has entered FRU (Field Replaceable Unit) iso-
lation mode. If the reader is reset, the sequence will be repeated. The following
table describes
the LED flashes/beep codes associated with an error found.
NUMBER OF LED
FLASHES/BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assis-
tance
2Interface PCB
4 Reader Module
5[Reserved]
6Digital PCB
14 CPLD/Code Mismatch
To Next Page
Loading...
