Enter/Exit Programming Mode Scanning Features
86 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Stand Mode Sensitivity
Sets the sensitivity level for stand mode wakeup. Choices are low, medium and
high.
Stand Mode Sensitivity = Low
Stand Mode Sensitivity = Medium
Stand Mode Sensitivity = High
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See "Scanning Active Time" on
page 302 for more
detailed programming instructions.
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
$CSNET
~
DEFAULT
005 = Scanning is active for 5 Seconds
To Next Page
Loading...
Need help?
General
