Enter/Exit Programming Mode Intercharacter Delay
36 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0
) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay. See "Intercharacter Delay" on
page 280 or "Intercharacter Delay" on
page 288 for more detailed programming instructions.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and not
save t
he entry string. You can then start again at the begin-
ning.
CANCEL
$CR2IC00
$CR2IC
~
DEFAULT
00 = No Intercharacter Delay
To Next Page
Loading...
