Enter/Exit Programming Mode Label Gone Timeout
76 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Label Gone Timeout
This feature sets the time after the last label segment is seen before the reader
prepares for a new label. The timeout can be set within a range of 10 millisec-
onds to 2,550 milliseconds (2.55 seconds) in 10ms increments. Label Gone
Time
out does not apply to scan modes that require a trigger pull for each label
that is read. See "Label Gone Timeout" on
page 299 for more detailed program-
ming instructions.
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
$CSNLG
~
To Next Page
Loading...
