Enter/Exit Programming Mode Double Read Timeout
74 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Double Read Timeout
To prevent a double read of the same label, the Double Read Timeout sets the
minimum time allowed between reads of labels of the same symbology and
data. If the unit reads a label and sees the same label again within the Double
Read Timeout, the second read of the label will be ignored. Double Read Time-
out does not apply to scan modes that requ
ire a trigger pull for each label that
is read.
Double Read Timeout = 0.1 Second
Double Read Timeout = 0.2 Second
Double Read Timeout = 0.3 Second
Double Read Timeout = 0.4 Second
Double Read Timeout = 0.5 Second
$CSNDR0A
$CSNDR14
$CSNDR1E
$CSNDR28
$CSNDR32
To Next Page
Loading...
Need help?
General
