RS-232 and USB-COM Interfaces Enter/Exit Programming Mode
Product Reference Guide
43
Indicate Transmission Failure
This option enables/disables the reader’s ability to sound an error beep to indi-
cate a transmission failure while in ACK/NAK mode
Indicate Transmission Failure = Disable Indication
Indicate Transmission Failure = Enable Indication
.
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "Disable
Character" on
page 285 for more detailed programming instructions.
NOTE
Select Disable Character Setting
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option
Data Bits
on page 31
has been set as 7 Data Bits.
$CR2TF00
$CR2TF01
DEFAULT
$CR2DC
DEFAULT
0x44 = Disable Character is ‘D’
To Next Page
Loading...
Need help?
General
