Enter/Exit Programming Mode Character Conversion
72 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4
character pairs represented in hexadecimal ASCII values. The first character in
the pair is the character that will be converted. The second character in the pair
is the character to convert to. If the character to convert in a pair is FF, then no
conversion is done. See "Character Conversion" on
page 297 for more detailed
programming instructions.
Configure Character Conversion
$CLFCH
0xFFFFFFFFFFFFFFFF
(No character conversion)
To Next Page
Loading...
