Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
87
Stand Mode Flash
Enables/disables the LED flash when the reader is in Stand Mode.
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. See "Flash On Time" on
page 303 for more detailed
programming instructions.
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
$CSMFL00
Stand Mode Flash = Disable
$CSMFL01
Stand Mode Flash = Enable
$CSNFN
~
DEFAULT
OA = Flash is ON for 1 Second
To Next Page
Loading...
Need help?
General
