Product Reference Guide
317
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of
Table 28. The settings in this table are as applied to a standard RS-232 inter-
face. See Table 29 for a listing of default exceptions to this list as applied to
other interface types. Page references are also provided for feature descriptions
and programming bar codes for each parameter. A column has also been pro-
vided for recording of your preferred default settings for these same configu-
rable features.
Table 28. Standard Defaults
Parameter Default Your Setting
Global Interface Features
Host Commands — Obey/Ignore
Obey
USB Suspend Mode
Enable
RS-232
Baud Rate
9600
Data Bits
8 Data Bits
Stop Bits
1 Stop Bit
Parity
None
Handshaking Control
Disable
RS-232/USB-COM
Intercharacter Delay
No Delay
Beep On ASCII BEL
Disable
Beep On Not on File
Enable
ACK Character
‘ACK’
NAK Character
‘NAK’
ACK NAK Timeout Value
600 ms
To Next Page
Loading...
Need help?
General
