Product Reference Guide 29
RS-232 ONLY Interface
Use the programming bar codes in this section if modifications to the standard
RS-232 interface settings are necessary to meet your system’s requirements.
Additional settings which apply to both the RS-232 and USB interfaces are
available in Chapter 6, RS-232 and USB-COM Interfaces.
BAUD RATE on page 30 PARITY on page 33
DATA BITS on page 31 HANDSHAKING CONTROL on page 34
STOP BITS on page 32
RS-232 Standard Factory Settings
Reference Appendix B, Standard Defaults for a listing of standard factory set-
tings.
To Next Page
Loading...
