Datalogic QuickScan I QD21 1 Series - Stand Mode Triggered Timeout

Enter/Exit Programming Mode Scanning Features
84 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
Stand Mode Triggered Timeout
This feature specifies the time to remain in Trigger Single on page 301 mode
after the trigger is pulled while in Autosense
®
Stand Mode on page 301.
NOTE
Stand Mode Triggered Timeout = 0.5 Seconds
Stand Mode Triggered Timeout = 1.5 Seconds
Stand Mode Triggered Timeout = 2 Seconds
Stand Mode Triggered Timeout = 3 Seconds
Stand Mode Triggered Timeout = 4 Seconds
This timeout is only used when the Scan Mode is configured as Auto-
sense
®
Stand Mode on page 301 .
$CSNOT01
$CSNOT03
$CSNOT04
$CSNOT06
$CSNOT08
DEFAULT