Enter/Exit Programming Mode ACK NAK Options
40 QuickScan™ I QD21X1 / QM21X1 / QBT21X1
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout. See "ACK NAK Timeout Value" on
page 283 for more
detailed programming instructions.
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
$CR2AT
~
01 ACK NAK Timeout value is 200ms
To Next Page
Loading...
Need help?
General
